Reply to thread

Message: [QUOTE="Queen, post: 90503, member: 27"] Ample Guitar M Lite 4 ships an 877 MB fingerstyle library sampled from a Martin D-41, with five articulations and drop tuning to D1. Sustain, palm mute, hammer-on and pull-off, legato slide, and pop. That is a full vocabulary, and most parts you hear online only ever trigger the first one. The result is the sound everyone clocks instantly as programmed. Even notes, even spacing, six strings ringing at once in ways no hand could manage. Fixing it takes roughly ten minutes per part, and almost none of that work happens in your DAW's piano roll. Start by learning what the keyswitches actually respond to. Not just which note picks which technique, but what your velocity does after you press it. [HEADING=2]Velocity does more work here than volume[/HEADING] Under C0, a note at velocity 127 fires the pop articulation instead of a sustain. So a passage you programmed at full velocity is not a loud fingerpick. It is a percussive snap on every single note, which is why hard-quantized parts sound brittle before you have touched an EQ. Palm mute runs the opposite way. Lower velocity on D0 gives you a deeper mute, so the quietest notes in a muted passage are also the most choked. A palm-muted run where every note sits at 80 hands you one mute depth for the whole bar. Legato slide and hammer-on behave differently again. High velocity on E0 moves the fret position, and low velocity leaves the hand where it is. F0 works on the same principle. Get it backwards, and the plugin slides from a fret no player could reach in time. [HEADING=2]The strings decide what your chord can be[/HEADING] Riffer 4 draws the six strings straight into the piano roll and blocks two notes from landing on the same one, assigning the fingering for you. That single rule kills the most common giveaway in programmed guitar, which is a chord voiced so tightly that no single hand could fret it. That matters because [B][URL='https://goldmidi.com/community/threads/ample-sound-debuted-the-free-ample-guitar-m-lite-4.75918/']the free Ample Guitar M Lite 4 library[/URL][/B] reuses one sampled pitch across string positions rather than recording every string and every fret separately. The engine leans on fingering logic to sell the illusion. Fight it, and you lose the one thing holding the performance together. Then use the tab view. Switch Riffer into guitar tab, look at where your notes have actually landed, and move anything sitting up at the twelfth fret in a part that should be open and ringing. Left-hand noises come baked into the library, and they only make sense when the fingering does. [HEADING=2]Doubling a take fixes what humanizing cannot[/HEADING] Riffer's humanize controls handle timing and velocity separately. You select the notes, set the amount, and hit Generate. Do velocity first, then timing, and keep both small, because minor inconsistency reads as human while large inconsistency reads as broken. Humanization still has a ceiling. Two slightly different performances of the same part, panned apart, beat one heavily randomized take every time, and Ample builds that in. The Doubled Guitars toggle runs a second instance internally, while the Double knob sets the timing offset between left and right channels. Small offsets give you [B]a naturally doubled acoustic guitar sound[/B]. Large ones give you a flam. For chords, the Strum Note controls matter more than any of this. A positive velocity gradient makes the pick dig in harder as it crosses toward the high strings, which is what a downstroke does. Reverse it for upstrokes. Then set strum time short for a tight chord hit, or long enough that the notes separate into an arpeggio, and vary that value between bars so no two chords land identically. One limit is worth planning around. Riffer caps out at 64 measures in the free build, so longer arrangements need splitting across regions, or exporting to MIDI and running the part from your DAW instead. [/QUOTE]

Name