Reply to thread

Message

[QUOTE="Tanonoka, post: 15914, member: 2313"]
Just so you know, there is no best setting for iZotope's RX Resample because of subjective tastes.

Some people don't like linear phase so what they do is set iZotope RX Resample's pre-ringing to 0 (minimum-phase filter), some folks like mixed-phase and that's anywhere in between 0 and 1. Ah well, it's different strokes for different folks really. But I'd recommend the following when doing SRC from 96,000 to 44,100 sampling frequency.
[CENTER][/CENTER]
[TABLE]
[TR]
[TH][LEFT]RX Resample "parameter"[/LEFT][/TH]

[TH][LEFT]RX Resample "value"[/LEFT][/TH]
[/TR]
[TR]
[TD]New sampling rate[/TD]
[TD]44,100[/TD]
[/TR]
[TR]
[TD]Change tag only[/TD]
[TD]off[/TD]
[/TR]
[TR]
[TD]Filter steepness[/TD]
[TD]32 or 38[/TD]
[/TR]
[TR]
[TD]Cutoff shift[/TD]
[TD]94 or 93[/TD]
[/TR]
[TR]
[TD]Pre-ringing[/TD]
[TD]1 (i.e., [I]linear-phase filter[/I]) or 0 (i.e., [I]minimum-phase filter[/I])[/TD]
[/TR]
[/TABLE]

Sometimes you have to enable the "Post-limiter" to get rid of extra inter-sample peaks especially when you opt to use 0 (i.e., minimum-phase filter) as your pre-ringing setting. Nevertheless, it's all a matter of taste.
[/QUOTE]

Name