Gorilla DSP's Lush Reverb packs three engines and 12-band EQ

Gorilla DSP has launched Lush Reverb, a $49 plugin with three reverb engines and a 12-band EQ. Windows users get a mix of smooth room sounds, bright shimmer, and spring effects, all in one tool.

The main reverb can go from a small room to a long hall. Decay runs from 0.2 to 40 seconds, with an Infinite mode for tails that keep going. Distance sets the space, while Pre-Delay can reach 500 ms.

Then there's the Moon knob. At low levels, it gives the reflections a warm, dark tone. Crank it higher, and the shimmer gets clear and bright. The spring model adds its own drip and chirp, with a knob that blends it into the main effect.

Sound control gets quite deep. Width spans 0% to 200%, while Brightness sets how fast the high end fades. Modulation adds slight changes to the tail, and Smooth can shift the sound from clear echoes to a thick wash.

Users can also pick Lush or Vintage density, then choose Warm or Natural tone. The Mix knob has a neat split in how it works. Below 50%, it adds wet sound while the dry level stays fixed. Above that, it fades toward a full wet signal.

And the EQ only touches the reverb, not the source audio. Its 12 bands offer nine filter shapes, from bells and shelves to cuts, notches, band-pass, and tilt modes. Each band has a solo switch, and users can drag points on a live spectrum view before or after processing.

For anyone who prefers presets, 93 factory patches cover halls, plates, rooms, ambience, shimmer, and springs. Lush Reverb runs on Windows as a VST3 or AAX plugin.
 

Attachments

  • Gorilla DSP's Lush Reverb packs three engines and 12-band EQ.webp
    Gorilla DSP's Lush Reverb packs three engines and 12-band EQ.webp
    61.8 KB · Views: 1

Sponsored

Top